Self Inflating Kooshion & Sky Bunk Instructions

Self Inflating Kooshion & Sky Bunk Instructions


Preparation:

Unpack and Stretch Out

Upon receiving your product, remove it from the packaging and fully stretch it out. Ensure the orange valve is turned fully clockwise and that the clear valve is securely fastened.

Initial Inflation

Find the green and grey cover (opposite side to the orange valve). Twist to remove the cover.

Press the black button to start inflation. The device will begin to inflate automatically.

    Once fully inflated (indicated by a slight change in noise and visibly by the fullness and firmness of the product), press the black button again to stop inflation.

      Replace the green cover and leave the product inflated overnight or for 12 hours to test for any leaks.

      Deflation and Storage:

        To deflate, unscrew the orange valve or pull the clear and black plug. For rapid deflation you can use both methods.
          Once fully deflated, replace all caps to prevent loss.

            Fold the product, store it in its bag, and it’s ready for your flight.

             

            Usage During Flight

            Only inflate your product/s when the seatbelt sign has been switched off.

            Position the Kooshion on the floor, with the button facing outward or for the Sky Bunk, place it on the seat with the orange valve hanging over the edge.

            Remove the green cover, press the black button, and then press it again once fully inflated. Ensure all caps are replaced after use.

            Deflation:

            If instructed by flight crew during turbulence or before descent, deflate the device following the same steps as in the initial test.


            Troubleshooting

            Air Leakage:

            If you notice any air being released, ensure that the orange valve is tightly secured (clockwise) and the black and clear plug is fully inserted.

            It is normal for some air to escape during the flight; simply press the inflation button briefly to top up as needed.

            Power & Charging:

            If the device does not turn on, press the on button several times to allow it time to power up.

            The internal pump can be charged if needed. Charge by removing the pump from the product - twist and pull the grey pump from out of the inflatable, locate the charging hole, and use the included charging cord to charge for 1-2 hours. A full charge should give you 100+ inflations. (You can also charge without removing the internal pump if easier).