Self-Inflating Sky Bunk™ – Instructions
✈️ Self-Inflating Sky Bunk Instructions
Create a lie-flat bed for your little one in under 30 seconds — no pump needed.
🔄 Know Your Model
We now have two versions of the Self-Inflating Sky Bunk:
1. Green Cap Version
-
Pump is located on the leg of the Sky Bunk
-
Twist + pull to remove the pump
-
Type-C charging (can charge attached or removed)
-
Red light = charging, blue = fully charged
-
Must use the included cable to ensure correct charging
2. Grey Cap Version (From October 2025)
-
Pump is located on the top of the Sky Bunk for easy access in-flight
-
Pull to remove (no twisting)
-
Must be removed to charge
-
Charging takes ~1 hour
-
Switch is orange — flick to inflate, flick again to stop
-
Tip: Pump can be inserted backwards post-flight to remove final air (see Deflation section)
🧳 Preparation
Stretch and Test Your Sky Bunk
-
Remove from packaging and fully stretch it out
-
Inflate and leave overnight (or for 12 hours) to test for leaks
-
If it holds air, register your warranty within 72 hours of receiving
Click here to register your lifetime warranty.
💺 Inflation & Use
Inflate While in Place
-
Set up your Sky Bunk on the plane with the legs hanging over the seat edge
-
Ensure it's correctly positioned before inflating — it inflates quickly
To Inflate:
Green Cap Version:
-
Twist and remove the green cap
-
Double-click the button to start inflation
-
Wait until it feels firm or the motor sound changes
-
Click once to stop, and quickly reattach the green cap (twist tightly)
Grey Cap Version:
-
Remove the grey cap
-
Flick the orange switch to turn on
-
Flick again to stop once inflated
-
Quickly reinsert and twist the grey cap back on to seal
During Use:
-
The Sky Bunk is designed for use once the seatbelt sign is off
-
You can top up the air mid-flight if needed by briefly turning the pump back on
🔧 Safety Tip
Ensure air safety release valve (red, orange or black) is twisted fully clockwise
Then, twist back slightly (about 2cm) to activate its auto-release function for in-flight pressure changes
🧳 Deflation & Packing
Step 1: Rapid Deflation
-
Pull open the Rapid Release Valve
-
Press the Sky Bunk down — air will begin escaping quickly (~3 seconds)
Optional:
-
Twist and remove the air safety release valve to speed up deflation
Step 2: Compress
-
Roll or press the Sky Bunk from one end, pushing all air toward open valves
-
If you have the grey cap model, remove the pump and insert it backwards
-
Turn on to vacuum the last bits of air
-
You will not see the orange switch, and the pump will only insert halfway — do not force it
-
Once complete, remove pump and store
-
Step 3: Fold & Pack
-
Replace all valves, fold the Sky Bunk, and pack for storage
-
Continue pressing out air as you fold to keep it compact
💡 Troubleshooting
If it’s not inflating:
-
Check battery is charged
-
Press the button/switch multiple times
-
Make sure all caps and plugs are removed or open
If it’s leaking air:
-
Ensure all valves (especially the air safety release) are fully sealed
-
Some air loss mid-flight is normal — top up with a quick burst of inflation